NAME

miredo-server.conf - configuration for miredo-server

SYNOPSIS

miredo-server.conf

DESCRIPTON

miredo-server.conf is the configuration file for miredo-server. Each configuration directive consists of one directive name, possibly followed by one or several spaces and a value for the directive. White spaces, empty lines and lines starting with '#' are ignored.

Directives are case-insensitive. A comprehensive list of the supported directives follows:

SERVER OPTIONS

ServerBindAddress server_ip

Specifies the primary IPv4 address of the Teredo server. miredo-server will bind to UDP/IPv4 port 3544 on this address and waits for packets from Teredo clients. It will advertise the Teredo prefix.

A Teredo server needs two subsequent IPv4 addresses. It will wait for UDP IPv4 packets on port 3544 on both addresses. server_ip specifies the lowest of both IPv4 addresses, which is known as the primary IPv4 server address. The secondary IPv4 address should be server_ip + 1 and must also be assigned to the server.

ServerBindAddress2 server_ip2

It is possible to specify a secondary IPv4 server address manually. However, Miredo clients will need manual configuration (with the ServerAddress2 directive in miredo.conf). Other Teredo clients are believed not to support such setup.

InterfaceMTU mtu

This directive overrides the value of the MTU that is advertised to Teredo clients. The default value is 1280 bytes and should not be changed unless a protocol update requires it.

SyslogFacility facility

Specify which syslog's facility is to be used by miredo-server for logging. Possible values are: daemon (the default), local0, ... local7, kern and user (see syslog(2)).

SEE ALSO

miredo-server(8)

AUTHOR

Rémi Denis-Courmont <remi at remlab dot net>

http://www.remlab.net/miredo/