manpages

gnunet-testbed-profiler(1)

GNUNET-TESTBED-PROFILER(1) General Commands Manual GNUNET-TESTBED-PROFILER(1)

NAME

gnunet-testbed-profiler — profiling driver for the testbed

SYNOPSIS

gnunet-testbed-profiler [-c FILENAME | --config=FILENAME] [-e COUNT | --num-errors=COUNT] [-H FILENAME | --hosts=FILENAME] [-h | --help] [-L LOGLEVEL | --loglevel=LOGLEVEL] [-l LOGFILE | --logfile=LOGFILE] [-n | --non-interactive] [-p COUNT | --num-peers=COUNT] [-v | --version]

DESCRIPTION

gnunet-testbed-profiler is a command line profiling driver for the testbed.

OPTIONS

-c FILENAME | --config=FILENAME
Use the configuration file FILENAME.
-e COUNT | --num-errors=COUNT
Tolerate COUNT number of continious timeout failures.
-H FILENAME | --hosts=FILENAME
Name of the file with the login information for the testbed.
-h | --help
Print short help on options.
-L LOGLEVEL | --loglevel=LOGLEVEL
Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
-l LOGFILE | --logfile=LOGFILE
Configure logging to write logs to LOGFILE.
-n | --non-interactive
Run profiler in non-interactive mode where upon testbed setup the profiler does not wait for a keystroke but continues to run until a termination signal is received.
-p COUNT | --num-peers=COUNT
Create COUNT number of peers.
-v | --version
Print GNUnet version number.

SEE ALSO

The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command

info gnunet

should give you access to the complete handbook,

info gnunet-c-tutorial

will give you access to a tutorial for developers.

Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).

BUGS

Report bugs by using https://bugs.gnunet.org or by sending electronic mail to <gnunet-developers@gnu.org>.

September 13, 2014 Linux 6.12.85-6.12-alt1