nethogs(8)
| NETHOGS(8) | System Manager's Manual | NETHOGS(8) |
NAME
nethogs - Net top tool grouping bandwidth per process
SYNOPSIS
nethogs [-V] [-h] [-x] [-d seconds] [-v mode] [-c count] [-t] [-p] [-s] [-a] [-l] [-f filter] [-C] [-b] [-g period] [-P pid] [device(s)]
DESCRIPTION
NetHogs is a small 'net top' tool. Instead of breaking the traffic down per protocol or per subnet, like most such tools do, it groups bandwidth by process - and does not rely on a special kernel module to be loaded. So if there's suddenly a lot of network traffic, you can fire up NetHogs and immediately see which PID is causing this, and if it's some kind of spinning process, kill it.
Options
- -V
- prints version.
- -h
- prints available commands usage.
- -x
- bughunt mode - implies tracemode.
- -d
- delay for update refresh rate in seconds. default is 1.
- -v
- view mode (0 = kB/s, 1 = total kB, 2 = total bytes, 3 = total MB, 4 =
MB/s, 5 = GB/s). default is 0.
kB: 2e10 bytes, MB: 2e20 bytes, GB: 2e30 bytes
- -c
- number of updates. default is 0 (unlimited).
- -t
- tracemode.
- -p
- sniff in promiscuous mode (not recommended).
- -s
- sort output by sent column.
- -l
- display command line.
- -a
- monitor all devices, even loopback/stopped ones.
- -C
- capture TCP and UDP.
- -b
- Display the program basename.
- -g
- garbage collection period in number of refresh. default is 50.
- -P
- Show only processes with the specified pid(s).
- -f
- EXPERIMENTAL: specify string pcap filter (like tcpdump). This may be removed or changed in a future version.
device(s) to monitor. default is all interfaces up and running excluding loopback
INTERACTIVE CONTROL
- q
- quit
- s
- sort by SENT traffic
- r
- sort by RECEIVED traffic
- l
- display command line
- b
- display the program basename
- m
- switch between total (KB, B, MB) and throughput (KB/s, MB/s, GB/s) mode
RUNNING WITHOUT ROOT
In order to be run by an unprivileged user, nethogs needs the cap_net_admin and cap_net_raw capabilities. Additionally, to display process names, cap_dac_read_search and cap_sys_ptrace capabilities are required. These can be set on the executable by using the setcap(8) command, as follows:
sudo setcap "cap_net_admin,cap_net_raw,cap_dac_read_search,cap_sys_ptrace+pe" /usr/local/sbin/nethogs
Notes
1. When using the -P <pid> option, in a case where a process exited (normally or abruptly), Nethogs does not track that it exited. So, the operating system might create a new process (for another program) with the same pid. In this case, this new process will be shown by Nethogs.
SEE ALSO
netstat(8) tcpdump(1) pcap(3)
AUTHOR
Written by Arnout Engelen <arnouten@bzzt.net>.
| 14 February 2004 |